HART HPCS25, Руководство оператора, Страница: 7 / 36

7 - English
OPERATION
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you
are assembling parts, making adjustments, cleaning,
or when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal
injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:

Cutting all types of wood products (lumber, plywood,
paneling, composition board, and hardwood)
WARNING:
Never use abrasive cut-off wheels of any kind with
this saw. Use of non wood cutting blades can result in
property damage or serious personal injury.
INSTALLING/REMOVING BATTERY PACK
See Figure 3, page 12.

Insert the battery pack into the battery port as shown.

Make sure the latch on the battery pack snaps into place
and the battery pack is secured in the product before
beginning operation.

Depress the latch and pull to release and remove the
battery pack.
For complete charging instructions, see the operator’s
manuals for your battery pack and charger.
WARNING:
Battery tools are always in operating condition. Lock
the switch when not in use or carrying at your side,
when installing or removing the battery pack, and when
installing or removing blades and accessories.
KICKBACK
See Figures 4 - 7, pages 12 and 13.
Kickback occurs when the blade stalls rapidly and the saw
is driven back towards you. Blade stalling is caused by any
action which pinches the blade in the wood.
DANGER:
Release switch immediately if blade binds or saw stalls.
Kickback could cause you to lose control of the saw.
Loss of control can lead to serious injury.
To guard against kickback, avoid dangerous practices
such as the following:

Setting blade depth incorrectly.
 Sawing into knots or nails in workpiece.

Twisting the blade while making a cut.
 Making a cut with a dull, gummed up, or improperly set
blade.

Supporting the workpiece incorrectly.
 Forcing a cut.

Cutting warped or wet lumber.

Operating the tool incorrectly or misusing the tool.
To lessen the chance of kickback, follow these safety
practices:

Keep the blade at the correct depth setting. The depth
setting should not exceed 1/4 in. below the material being
cut.

Inspect the workpiece for knots or nails before cutting.
Never saw into a knot or nail.

Make straight cuts. Always use a straight edge guide
when rip cutting. This helps prevent twisting the blade.

Use clean, sharp, and properly set blades. Never make
cuts with dull blades.

Support the workpiece properly before beginning a cut.
 Use steady, even pressure when making a cut. Never
force a cut.

Do not cut warped or wet lumber.
 Hold the saw firmly with both hands and keep your body
in a balanced position so as to resist the forces if kickback
should occur.