HART HLPM02, Руководство оператора

Страница: 15 / 40

11 – English
TROUBLESHOOTING
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM POSSIBLE CAUSE SOLUTION
Handle not in position. Handle adjustment knobs and/or handle
lock clips are not secured. Make sure handle adjustment knobs
are fully seated and handle lock clips
are fully closed.
Mower not starting. Battery is low in charge.
Start key not installed.
Handle assembly is not in operating
position.
Charge the battery.
Install start key.
Raise lower and upper handle.
Mower cutting grass unevenly. Lawn is rough or cutting height not set
properly.
Adjust the cutting height.
Mower not mulching properly. Wet grass clippings sticking to the
underside of the deck. Wait until the grass dries before mowing.
Mower hard to push. High grass, rear of mower housing and
blade dragging in heavy grass, or cut -
ting height too low.
Raise cutting height.
Mower not bagging properly. Cutting height set too low. Raise cutting height.
Mower vibrating at higher speed. Blade is unbalanced, excessively or
unevenly worn.
Bent motor shaft. Replace the blade.
Stop the motor, remove start key and
battery. Inspect for damage. Have
repaired by an authorized service center
before restarting.
Motor stops while cutting. Cutting height set too low. Raise the cutting height.