11 – English
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
SOLUTION
Handle not in position.
Handle adjustment knobs and/or han
-
dle lock clips are not secured.
Make sure handle adjustment knobs are
fully seated and handle lock clips are
fully closed.
Mower not starting.
Battery is low in charge.
Start key not installed.
Handle assembly is not in operating
position.
Charge the battery.
Install start key.
Raise lower and upper handle.
Mower cutting grass unevenly.
Lawn is rough or cutting height not set
properly.
Adjust the cutting height.
Mower not mulching properly.
Wet grass clippings sticking to the
underside of the deck.
Wait until the grass dries before mowing.
Mower hard to push.
High grass, rear of mower housing
and blade dragging in heavy grass, or
cutting height too low.
Raise cutting height.
Mower not bagging properly.
Cutting height set too low.
Raise cutting height.
Mower vibrating at higher speed.
Blade is unbalanced, excessively or
unevenly worn.
Bent motor shaft.
Replace the blade.
Stop the motor, remove start key and
battery. Inspect for damage. Have re
-
paired by an authorized service center
before restarting.
Motor stops while cutting.
Cutting height set too low.
Raise the cutting height.
