Product:
Code:
SHE-010/015/020/025/030/035/076
Premier Curved Team Shelter
Page 5
7.) Once all the plastic is in place the
crossbar (6) needs to be fixed into
position. Attach the crossbar using the self
tapping screws (25) by locating the holes
in the crossbar and lining those holes up
with the screw port in the extrusion in the
bent supports. It is best to screw in the end
screws first so that the crossbar is
supported at both ends. You then need to
tighten up the middle 3 screws gradually
as the crossbar pulls onto the face of the
bent supports.
. When
doing so make sure the PET sheets are
lined up to fit into the recess of the
crossbar. This is important as this will
hinder the screws from pulling into the
supports.
You will need a 10mm deep
drive socket/FAS005 (30) for this
Figure 10
26
25
27
6
Figure 12
28
6
.) At this point the back sheets (9) need to be slid
into place. Again this is a 3 person task, one person
will need to hold and support the weight of the sheet
and the other 2 to guide and push the sheet into the
recess into position. The sheets need to slide into the
recess of the extrusion of the bent supports, where
the rubber is located (shown more clearly in figure
11).
.
The sheet must slide in square, otherwise it will grip
on the rubber and wont slide in. As the plastic sheet
nears the bottom, make sure you line it up with the
back support slot so when it reaches the bottom it will
locate in position.
Note: It is recommended to use some kind of
silicone lubricant to aid the plastic sheets to slide in
Note: There will be an overhang of approx 13mm at the
top of the support.
9
Figure 11
9
3
When the crossbar is fitted tightly you can finish it off by inserting
the round caps (26) into the front of the crossbar and the end
caps (27) in either end of the crossbar by using the 10g self
tapping screws (
) (Figure 12).
29
