HARO SKWAD, Руководство пользователя

Страница: 10 / 36

10
Charging procedure
To charge your battery, mind the advice in “Before you charge” on Page 9 and then
follow these steps.
1. Ensure the battery power is off. Push the power button on the controller until the screen
goes blank.
2. Open the rubber cover on the charging port on the on the side of the battery, near the
keyport (see image on page 11). Note that the keyport does not have a cover.
3. Plug the charger into the battery’s charging port. Keep the battery installed on the bike,
or remove the battery and place it on a hard, smooth, flat surface with the charging
indicator lights facing up. Connect the DC output plug from the charger (round barrel
connector) to the charging port on the side of the battery.
4. Plug the charger into a power outlet. Connect the charger input plug (120-volt plug) to
the power outlet. Charging should initiate and will be indicated by the LED charger light
turning red. When charging is complete, the indicator light will turn green.
5. Once fully charged, indicated by the charging indicator light turning green, unplug the
charger from the wall outlet first and then remove the DC output plug (round barrel
connector) from the battery charging port. Be sure to pull gently on the plugs, not on the
cables themselves.
NOTICE : The charger is designed to stop charging automatically when the battery is full.
Nevertheless, leaving your battery charging longer than necessary can cause needless
wear. We recommend you remove the charger from the battery within one hour of the green
light indicating a complete charge. Store the charger carefully, making sure its plug does
not come in contact with liquids, dirt, debris, or metal objects, which can damage the plug
and interfere with future operation.
TIP! We recommend you follow these steps when plugging in and unplugging your charger.
To plug in your charger:
1. Start with the charger unplugged from both the power outlet and battery.
2. Plug the charger into the battery.
3. Plug the charger into the power outlet.
To unplug your charger:
1. Start with charger plugged into both the power outlet and battery.
2. Unplug the charger from the power outlet.
3. Unplug the charger from the battery.
WARNING
: Charging your battery with a charger other than one supplied by Haro
Bikes and designed for your specific bike’s serial number can cause damage to
your bike’s electrical system or create a fire hazard. Only use a battery charger
designed for your bike and supplied by Haro Bikes.
CAUTION : An unlocked or improperly attached battery can fall off a moving bike,
causing damage or injury. Always check that the battery is properly attached and
locked to the frame before moving or riding your bike.