Installing the PWRLink II Transmitter
2–4
Copyright © 2002 Harmonic Inc.
the signal source connector into the PWRLink II module RF input connector
and tighten securely. The input video signal level must be between 16 dBmV
and 22 dBmV per analog video channel based on 76 PAL channels.
NOTE:
To ensure performance integrity, use RG-59 coaxial cable. Use of a
connector with a center pin diameter greater than 0.8 mm can
damage the input RF connector.
2.5
Testing RF Signal Input
Once you have connected the RF signal source, you can use the RF monitor to
verify the presence of the RF signal input to the transmitter. The RF monitor is
a test connector (female F-type) located on the front panel of the transmitter
module, as shown in Figure 1-1 on page 1-2. The monitor level is 20 dB below
the input level to the transmitter ±1 dB.