Harmar Mobility SL600 HD, Инструкция по установке и обслуживанию

Страница: 10 / 20

SL600HD Heavy Duty Stair Lift: Installation & Service Manual
31JAN2020 | P/N: 75403 REV C
10
HEAVY DUTY STAIR LIFT: SECTION 4
INSTALLATION
Place the other rail on the last step before the
top landing, again tightening it so it touches the
rear of the last step. See Figure 4-4.
Figure 4-4
9. Turn the rail right side up with the plastic side
facing up. See Figure 4-5.
Figure 4-5
10. Measure any obstruction from the wall (this may
include handrails, molding, light switches, etc.)
and adjust the edge of the brackets and equal
distance from the wall. The edge of the track
needs to be 7
" from the wall or any obstruction.
See Figure 4-6.
Figure 4-6
11. The underside of the rail must be at least 2 "
above the stair tread nose to provide clearance
for the footrest. To achieve this 2
" clearance
move the rail and bracket forward. Once the
clearance is 2
" tighten all bracket nuts to hold
the brackets in position. To maintain the 2 "
clearance, and hold the rail in place, secure the
bottom bracket to the first step from the floor
with two 2
" wood screws, using a 3/8 " nut driver
on a 6 " -10 " extension of a cordless drill.
CHASSIS INSTALLATION
1. Remove the plastic bag from the chassis box.
Lift the chassis with the manual override hole
(on bottom) facing the downhill side of the stairs
and gently slide the chassis onto the rail until it
makes contact with the plastic rack.
DO NOT
LET THE CHASSIS FALL DOWN THE RAIL.
See Figure 4-7.
Figure 4-7
2. Remove the safety tie and turn the red “On/OFF”
switch to the “ON” position. See Figure 4-8.
Figure 4-8
Remove two pieces of gear rack from the top end of
the track before installing the chassis.
NOTICE
Be careful not to trap fingers between the rail
and the chassis.
CAUTION
!