Harmar Mobility SL600 HD, Инструкция по установке и обслуживанию

Страница: 12 / 20

SL600HD Heavy Duty Stair Lift: Installation & Service Manual
31JAN2020 | P/N: 75403 REV C
12
HEAVY DUTY STAIR LIFT: SECTION 4
INSTALLATION
Figure 4-13
6. Install one of the rack pre-compression screws
in the threaded hole in the top rail plate; tighten
as firmly as possibly by hand with a 5/32
" Allen
wrench. See Figure 4-14.
There are three kinds of pre-compression
screws:
• 1
" for tracks under 6 '
• 1 1/4 " for tracks between 6 ' and over
Figure 4-14
7. Plug in the battery charger at either end of the
rail, choosing the closest or most convenient
location of a wall power supply. Minimize wire
length and intrusion.
FOOTREST & SEAT
INSTALLATION
1. Remove footrest from box and use the
installation switch to drive the chassis
downward to a position about 6
" clear of the
floor. This provides a safe area to install and
adjust the footrest. Do not drive the unit into
the bottom stop. See Figure 4-15.
Figure 4-15
2. Turn the red “On/Off” switch located on the top
of the chassis to the “OFF” position.
3. Position the footrest onto the two seat-leveling
bolts on the outside of the chassis by aligning
the large opening at the slot ends of the footrest
See Figure 4-16.
Figure 4-16
4. Ensure the footrest if fully engaged.
5. Position the rear seat support onto the two seat-
leveling bolts on the backside of the chassis by
aligning the large opening at the slot ends of the
footrest. See Figure 4-17.
Too much torque applied to these screws may
result in damage. Take your time and apply
grease to threads.
CAUTION
!