Harmar Mobility SL600 HD, Инструкция по установке и обслуживанию

Страница: 11 / 20

SL600HD Heavy Duty Stair Lift: Installation & Service Manual
31JAN2020 | P/N: 75403 REV C
11
HEAVY DUTY STAIR LIFT: SECTION 4
INSTALLATION
3. Use the installation switch (the black switch on
the top of the chassis) to move the chassis at
least two feet down the rail, pushing gently on
the chassis to ensure the chassis does not pull
any rack to the top. See Figure 4-9.
Figure 4-9
FINAL RAIL INSTALLATION
1. Install the remaining plastic rack pieces in the
upper rail. See Figure 4-10.
Figure 4-10
2. Use a hacksaw or chop saw to cut the last
plastic rack piece flush with the rail end. Place
something on the floor to catch debris or mark
and cut the rack outside.
The exposed, cut end of the plastic rack should
face the top end of the rail (the factory-cut side
should butt against the lower rack).
See Figure 4-11.
Figure 4-11
3. Slide the top limit cam into one of the cam slots
(either side), and tighten the pre-inserted Allen
screw with a 5/64 Allen wrench. This will be
used to set the final upper limits for the stair lift.
See Figure 4-12.
Figure 4-12
4. Remove the charging strip from the rail box.
Connect charging strip connector to the charger
wire that runs through the center of the rail from
the lower charging strips.
Insert the two charger strips into the keyed slots
at the top of the rail (while standing on the top
landing looking down). The charging strip with
the red wire should be inserted into the left slot
with the metal strip facing out. The charging
strip with the black wire should be inserted into
the right slot with the metal strip pointing out.
Bend the red and black wire tabs in toward the
center of the rack.
Insert excess cable into the rail, leaving the
pigtail with the Molex connector.
5. Install the end plate to the top of the rack with
the four self-cutting Torx screws using the
supplied T30 Torx bit. See Figure 4-13.
Do not ride on the chassis or lift until the install
is complete.
CAUTION
!