| www.harmar.com | 800-833-0478
20
SECTION 2 : INSTALLER
Installation
Post Installation
1. Loosen set screws
and insert vertical post.
[Figure 20-3 ]
The average installation will require approximately 180 degrees
of rotation as shown.
[Figures 20-1 & 20-2]
180
2" Increments
1" Fine Tuning
Increment
Loosen
Set Screws
(x4)
Adjust set screws until
post is vertically level.
3/8-16 x 3-1/2"L
Hex Head Cap Screw
3/8-16
Nyloc Nut
MINIMAL
2. Plug in the hand control and turn the lift ‘On.’
Press the 'In /Out' button to test the post height.
[Figure 20-4]
Ideally, the post’s horizontal tubing should just
clear the truck’s bed side wall. Adjust height as
required.
Figure 20-1
Figure 20-2
Figure 20-3
Figure 20-4
