Harmar Mobility AL625HD, Инструкция по установке и эксплуатации

Страница: 8 / 28

AL625 & AL625HD Page 8
REV: 1-24-12
MOUNTING THE TRACKER DIRECTLY TO THE VEHICLE’S FLOOR
The Tracker may be installed by bolting the Side Mounting Rails of the Trolley Assembly to the vehicle’s
floorboard if there is a suitable mounting surface and are no obstructions (fuel tank, brake lines, etc.)
WARNING:
CHECK FOR VEHICLE COMPONENTS UNDER THE FLOORBOARD BEFORE
DRILLING ANY HOLES. CHECK THE AREA BENEATH THE VEHICLE IN THE
INTENDED INSTALLATION LOCATION TO BE SURE YOU WILL NOT PIERCE OR
CONTACT THE FUEL TANK, ELECTRICAL WIRING, BRAKE LINES, ETC.
CHECK FOR RUST DAMAGE OR COLLISION REPAIR THAT MAY COMPROMISE
THE VEHICLE’S STRUCTURAL INTEGRITY.
Fold back or remove the carpet in the area to expose the metal floorboard. The Trolley Assembly must be mounted
to a relatively flat surface. Small irregularities, such as stiffening channels, may be shimmed with washers when the
Trolley Assembly is bolted down. On most installations, the carpet can be folded back into place and trimmed
around the Side Mounting Rails so that it will be captured neatly against the Trolley Assembly. Use your best
judgment and strive for a neat installation.
Place the Trolley Assembly in the desired position on the floor of the vehicle’s cargo area and mark the four hole
locations with a 3/8” center punch. Remove the Trolley Assembly and drill the four holes for the mounting bolts
using a 3/8” drill bit. BE VERY CAREFUL NOT TO DAMAGE ANYTHING ON THE UNDERSIDE OF THE
TRUNK WHEN THE DRILL BIT PUNCHES THROUGH THE METAL FLOOR.
Install the Trolley Assembly with the 3/8” X 2.5” Bolts, 3/8” Flat Washers, Hex Washer Plates and 3/8” Locking
Nuts provided. If shims are necessary (to compensate for irregularities in the trunk floor or to level the Trolley
Assembly) use additional 3/8” ID Flat Washers (not included). Attach a 3/8” Washer and a 3/8” Self-Locking Nut
to the Hex Washer Plate and Bolt from the underside of the vehicle and tighten securely. At this time, the washers
and nuts that mate to the underside of the vehicle should be sealed with silicone sealant to prevent moisture from
entering the holes and rusting the vehicle’s floor or Trolley Assembly.
CAUTION: FAILURE TO SECURELY FASTEN ALL THE BOLTS MAY RESULT IN
DAMAGE TO THE LIFT OR VEHICLE’S FLOOR. THIS CONDITION MAY CAUSE
THE UNIT TO FAIL UNDER LOAD, THUS RISKING PERSONAL INJURY TO THE
OPERATOR AND DAMAGE TO THE POWER CHAIR/SCOOTER AND/OR TO THE
VEHICLE.
STEP 3