ONCE CONFIDENCE HAS BEEN GAINED ON THE POSITION OF THE LIFT,
AND THE “TRIAL FIT” PROCEDURE HAS BEEN COMPLETED, THREE 3/8”
HOLES WILL NEED TO BE DRILLED IN THE MARKED LOCATIONS
ONCE HOLES ARE DRILLED, FASTEN BASE TO VEHICLE
FLOOR USING SUPPLIED HARDWARE IN THE HARDWARE
PACK. BE SURE TO TIGHTEN ALL FASTENERS.
AL-055 INSTALLATION
ALL THREAD KIT MAY BE REQUIRED
ALL THREAD KIT MAY BE REQUIRED
SOME VEHICLES HAVE STORAGE
COMPARTMENTS IN THE REAR CARGO
AREA, POTENTIALLY EFFECTING LIFT
PLACEMENT. MOST OF THESE CAN BE
OVERCOME WITH THE AID OF AN
ALL THREAD KIT. SHOWN ABOVE IS THE
TYPICAL APPLICATION FOR
OVERCOMING THESE STORAGE
COMPARTMENTS OR WELLS.
SPARE TIRE STORAGE:
SOME VEHICLES STORE
THE SPARE TIRE UNDER
THE FLOOR OF THE VEHICLE.
MAKE SURE THAT THE BASE
CAN BE BOLTED THROUGH
A STEEL FLOOR OR FRAME.
AT
-01
STORAGE
WELL
LID
Vehicl
e
Floor
Vehicl
e
Floor
Vehicl
e
Floor
INSTALLATION TIP:
CHOOSE A SAFE LOCATION IN WHICH TO
DRILL A SINGLE PILOT HOLE FROM ABOVE
IN ONE OF THE 3 MARKED LOCATIONS.
LOOK UNDERNEATH THE VEHICLE
AND MEASURE OUT THE SPECIFIED
DISTANCE FROM THE PILOT HOLE.
IF ALL IS CLEAR IN THAT AREA, CONTINUE
TO DRILL PILOT HOLES IN REMAINING
LOCATIONS.
INSPECT ALL THREE PILOT HOLES FROM
UNDER THE VEHICLE. IF ALL CLEAR, DRILL
3/8” HOLES IN PILOT LOCATIONS
CAUTION! AVOID THE VEHICLE
WIRING, FUEL LINES, FUEL TANKS
SPARE TIRES, ETC. WHEN DRILLING
CAUTION! AVOID THE VEHICLE
WIRING, FUEL LINES, FUEL TANKS
SPARE TIRES, ETC. WHEN DRILLING
PLACE POST INTO BASE.
SLIDE SHAFT COLLAR OVER POST
TIGHTEN SET SCREW.
SLIP-ON ARM ASSEMBLY ONTO BASE..
ADJUST ARM HEIGHT WITH SET SCREW
AS NEEDED (POST MAY BE
CUT IF REQUIRED).
ONCE REQUIRED HEIGHT IS
DETERMINED, DRILL 1/4” HOLE
THRU POST USING SHAFT COLLAR
AS A GUIDE.
BOLT SHAFT COLLAR TO POST
USING SUPPLIED 1/4” BOLT AND NUT.
ARM A
SSEMBL
Y
COLLAR
SET
SCREW
POST
BASE
BUSHINGS
6
