14
Check
( ) ( )
Install
(
6
)
nine pin sockets, V1 through V6, noting orientation. Use 4-40 x
⅜
˝ screws, lockwasher
under nut.
(
See Figure E.
)
( ) ( )
Install
(
4
)
octal sockets, noting orientation. Use #6-32 x
⅜
˝ screws. Place lockwasher under screw
head.
(
Lockwashers serve to ground tube socket to chassis.
)
( ) ( )
Install
(
2
)
phono receptacles
(
P1 and P2
)
from inside of
chassis. Use #6-32 x
⅜
˝ screws, lockwasher under nut.
P2 is a dual input jack. Install using phenolic shield and
grounding solder lug. Refer to Pictorial #4 & Figure M.
P1 is a single input jack and is similarly installed, but
without grounding lug.
( ) ( )
Install fuse holder
(
F
)
. Slide rubber washer on holder
before inserting. Use lockwasher and nut supplied.
( ) ( )
Install speaker terminal strip
(
T1
)
and lug strip
(
T3
)
.
Insert screw through T1 and install from outside of
chassis. Placing lockwasher on screw, insert lug strip T3
as shown. Install T2 and T4 in same manner. Use #6-32
x
⅜
˝ screws.
( ) ( )
Install AC receptacle
(
AC1
)
from inside of chassis. Use
#6-32 x
⅜
˝ screws, Lockwashers under nut.
( ) ( )
Install
(
2
)
dual pots
(
P3 and P4
)
. Place fishpaper solder shields between pot and chassis. Bend tabs to
fasten.
(
See Figure F
)
.
( ) ( )
Install
(
2
)
AC balance controls
(
P5 and P6
)
. Place fishpaper solder shields between control and
chassis. Mount with
⅜
˝ lockwasher and
⅜
-32 hex
nut.
(
See Figure G.
)
( ) ( )
Install meter with meter clamps and #6-32 x
⅜
˝
screws, lockwasher under nut.
(
See Figure H.
)
Remove fine wire shipping shunt before installing.
(
NOTE: Do not tighten the two meter bracket
nuts excessively, as this may result in damage to
the meter.
)
