13
The following capacitors are mounted to the rear
(
unprinted side
)
of the terminal board. The leads are bent
over the edges of the board to connect the lugs which are on the front side of the board. Connect the leads
snugly to the lower section of the lugs with one turn around the lug. Clip excess wire. Bands on capacitors indi -
cate outside foil. Polarity, except for electrolytic, is unimportant. Slip sleeving over all the capacitor lea ds as
shown in Pictorial #3, Figure C.
Check
TB1
TB2
( ) ( ) ( )
Connect a .22 mfd 600V from 1
(
NS
)
to 33
(
NS
)
.
( ) ( ) ( )
Connect a .47 mfd 600V from 14
(
S
)
to 21
(
NS
)
.
( ) ( ) ( )
Connect a .22 mfd 600V from 15
(
NS
)
to 19
(
S
)
.
( ) ( ) ( )
Connect a .47 mfd 600V from E-30
(
NS
)
to C-24
(
S
)
.
( ) ( ) ( )
Connect a 4 mfd 450V, positive end
(
)
to J-42
(
S
)
. Connect the other end to L-39
(
S
)
.
Dress the body of this capacitor
⅜
˝ from the terminal board, see Figure N.
THIS COMPLETES ASSEMBLY OF THE TERMINAL BOARDS. Put them away for later use.
CHASSIS ASSEMBLY
Use of a good screwdriver, properly ground,
(
not chisel-pointed!
)
, will reduce the possibility of scratching
and gouging the chassis.
Refer to Pictorial #4 for location and orientation of parts.
