Harman Kardon AVR 8000, Руководство пользователя

Страница: 43 / 60

43 PROGRAMMING THE REMOTE
Programming the Remote
Reassigning Device Control
Selectors
Although each Input Selector
e
is normally
assigned to the category of product shown on
the remote, it is possible to reassign one of
these buttons to operate a second device of
another type. For example, if you have two VCRs
but no satellite receiver, you may program the
“SAT” button to operate a second VCR. Before
following the normal programming steps for
either Three-Digit entry or Auto Search code
entry, you must first reassign the button with the
following steps:
1. Press the Input Selector
e
you wish to
reassign and the Mute Button at the
same time until the red light appears under
the
Input Selector
e
and the Program/
SPL Indicator
c
flashes amber.
2. Press the Input Selector
e
matching
the device type you wish to program into
the reassigned button.
3. Enter the three-digit code for the specific
model you wish the reassigned button to
operate.
4. Press the same Input Selector
e
pressed
in Step 1 once again to store the selection.
The red LED under the re-assigned Input
Selector will flash three times and then
go out.
Example: To use the CBL/SAT button to
operate a second VCR, first press the
CBL/SAT Input Selector
e
and the
Mute Button at the same time until
the red light glows under the CBL/SAT Input
Selector
e
button. Press the VCR Button
e
, followed by the three-digit code for the
specific model you wish to control. Finally,
press the
CBL/SAT Button
e
again.
Resetting the Remote Memory
As you add components to your home theater
system, occasionally you may wish to totally
reprogram the remote control without the confu-
sion of any commands, macros or ”Punch-
Through“ programming that you may have
done. To do this, it is possible to reset the
remote to the original factory defaults and
command codes by following these steps.
Note, however, that once the remote is reset,
all commands or codes that you have entered
will be erased and will need to be re-entered:
1. Press any of the Input Selector Buttons
e
and the O Button
r
at the same
time until the Program/SPL Indicator
c
begins to flash amber.
2. Press the 3 Button
r
three times.
3. The red LED under the Input Selector
e
will go out and the Program/SPL Indicator
c
will stop flashing and turn green.
4. The Program/SPL Indicator
c
will remain
green until the remote is reset. Note that this
may take a while, depending on how many
commands are in the memory and need to
be erased.
5. When the Program/SPL Indicator
c
goes
out, the remote has been reset to the factory
settings.
46
46