Charging process
The cPµ1 is designed to charge your vehicles as fast as possible according to IEC 61851-1
Mode 3. The effective charging time depends on the battery of your vehicle as well as on
the current residual energy. Therefore, it is not possible to give a binding statement
regarding the charging time.
In fact, you will determine the data upon practice and thus, develop your own personal
schedule for charging.
In order to charge your vehicle, please proceed as follows:
1. Check the LED-display on the front side of your cPµ1. If the charging station is ready, the
LEDs are glowing in green.
2. Plug the charging cable of the cPµ1 into the socket of your vehicle. The vehicle must be
parked accordingly so you can reach it comfortably. The cable
must
not
be strained
during the charging process.
3. Charging will start as soon as the cable connects with the socket of your vehicle. Upon
starting the LEDs colour will change to blue.
Completion of charging process
4. The charging process will not be terminated by the charging station but only by the
vehicle itself. Based on communication between the cPµ1 and your vehicle, the charging
station will give notification by switching the LED colour from blue back to green. This is
to signify that you can remove the charging cable.
5. Upon ending the charging process pull the cable out of the charging socket.
PLEASE NOTE!
Should any errors or malfunction occur during or after the charging process,
it will be indicated on the LED-Display of the charging station. The following
chapter describes how to recognize the operation status and/or error status
and which actions are necessary to be taken.
Instruction Manual
cPμ1
charging station
Version: 1.3.3
21
