Mechanical installation on wall
At least two persons are required to perform the following instructions. Additionally these
components will be required:
• An electric drilling machine or a cordless screwdriver (not included in scope of
delivery)
• A twist drill Ø 6 mm for the respective mounting surface (not included in scope of
delivery)
• A Torx-screwdriver or Torx-Bit TX20 (not included in scope of delivery)
• 4 fastening screws of size 4,0×45/40,5 with matching plastic screw anchors of size
6×35 mm (included in scope of delivery)
• if necessary: a level (not included in scope of delivery)
Please proceed as follows:
1. Take off the front cover of the housing by unscrewing the 4 screws in the
corners. Then carefully unplug the LED Display.
2. Mark the four drill holes on the wall by using the charging station as template.
3. Drill the previously marked spots (Ø 6 mm).
4. Insert the included screw anchors for the fastening screws.
5. Position the charging station so the drilled holes of the wall tally with the
ones of the cPµ1.
6. Now insert the fastening screws and tighten them.
7. Skip to step 3 of the electrical installation or follow step 8 to complete the
mechanical installation by closing the housing.
8. Before putting the cover back on, plug the LED-Display back in and then close
the lid over the housing. Use the screws to fasten it back to its place.
The mechanical installation is now complete.
PLEASE NOTE!
ATTENTION! Please check the measurements on the drilling template over with
a calibrated metering rule BEFORE drilling and marking the spots for the drilling
holes with help of the template.
Instruction Manual
cPμ1
charging station
Version: 1.3.3
16
