HARDKORR 135AH LiFePO4, Инструкция по эксплуатации

Страница: 15 / 24

15
CAUTION
Remote reset
switch & cable
BMS AND REMOTE
RESET SWITCH
Your battery comes equipped with an integrated advanced Battery
Management System (BMS). The BMS ensures there is an even energy
balance between cells and allows up to six of these batteries to be connected
in parallel or series.
The BMS contains an intelligent protection circuit module which protects
against overcharge, over-discharge, short-circuit and over-temperature, and
can shut off power to the battery if required.
It also contains a low-voltage disconnect, which will place the battery into
protection mode if it drops below 10.0V. If the low-voltage disconnect is
tripped, the battery will not accept a charge until it has been reset.
To reset the battery, you can use the included remote reset switch (pictured
below) which connects to the port on top of the battery. The switch can be
mounted somewhere in your 12V setup and the cable permanently connected,
or you can keep the switch and cable packed away and connected it when
required.
To use the switch, simply plug the cable it into the top port (if not permanently
connected) and hold down the button for five seconds.
You should now be able to charge the battery as normal.
By continuously tripping the low-
voltage disconnect you may cause
damage to sensitive electronic equipment
that is attached to the battery such as stereo
equipment. This is not covered under the
battery warranty.