Hardinge SERIES I, Установка, эксплуатация и обслуживание

Страница: 16 / 23

Move Ram Slide
1. Use wrench provided with machine to loosen
bolts “L” and “M”, Figure 2.25.
2. Use wrench to move the slide to the desired
position using bolt “N”.
3. Tighten bolts “L” and “M”, starting with the
rear bolt.
- NOTE -
It is recommended that on heavy mill-
ing work, head should be kept as close
to column as possible, where maxi-
mum rigidity is obtained.
Saddle Clamping
When milling with longitudinal table feed only, it is
advisable to clamp the knee to the column (see
Figure 2.27) and the saddle to the knee to add
rigidity to these members and provide for heavier
cuts with a minimum of vibration. The saddle locking
lever is located on the left hand side of the saddle.
Excessive moisture can cause slight table bind.
Use moderate clamping pressure, as this will hold
saddle sufficiently.
M-450 2-15
Figure 2.25 - Ram Slide
TP5309
L
N
M
Rear
Figure 2.26 - Saddle Clamping
TP5310
Unlock
Lock
Saddle
Locking Lever