SKU 91089
Page 5
5.
Using the Crank Handle (3), wind the hose (not provided) onto the Reel.
Guide the hose back and forth across the reel as you wind it on, loading
the hose onto the reel evenly.
6.
Move the assembled Hose Reel to your water supply outlet.
7.
Attach the male end of the Lead-in Hose to the Inlet Pipe (16) at the rear of
the assembly. Be sure the provided seal is in place, and tighten firmly to
prevent leaks.
8.
Attach the female end of the Lead-in hose to your water supply outlet. Be
sure the provided seal is in place, and tighten firmly to prevent leaks.
Operation
1.
You may now turn on the water supply and use your hose. If additional
hose is desired, simply pull more length off the reel.
2.
When you are through with the hose, rewind it on the reel by turning the
crank handle. Be sure to guide the hose onto the reel, so the reel is loaded
evenly. Be careful not to injure fingers or hands when you are rewinding
the reel.
3.
To move the reel to another location, simply detach the Lead-in hose from
the water supply outlet. Roll the reel to the desired location, and attach the
Lead-in hose to the new outlet.
Maintenance
1.
Store the hose reel and its attached hose out of direct sunlight.
2.
Do not allow the hose reel or its attached hose to be exposed to dirt,
grease, or corrosive materials. If it becomes contaminated, clean it off
right away, using clean water and a household detergent.
3.
If the hose reel leaks, check the hose attachments. Be sure the fittings are
in good condition, and are not contaminated with dirt or other materials. Be
sure the seals are correctly seated, and are in good condition. Be sure the
connections are tight. You may need to replace a damaged seal.
Handle Bolt and Nut
Lead-in Attachment Fitting
Hose Attachment Fitting
