Page 6
For technical questions, please call 1-888-866-5797.
Item 58672
Sa
Fety
Opera
ti
O
n
Maintenance
Setup
Lithium Battery Safety Warnings
LitHiuM BatterieS StOre a
LarGe aMOunt OF enerGy
anD WiLL Vent Fire Or
eXpLODe iF MiStreateD:
1.
Keep Battery pack dry.
2.
DO nOt DO any OF tHe FOLLOWinG
tO tHe Battery pacK:
• Open,
• Drop,
• Short-circuit,
• puncture,
• incinerate, or
• expose to temperatures
greater than 140°F.
3. Charge Battery Pack only according
to its Charger’s instructions.
4. Inspect Battery Pack before every use;
do not use or charge if damaged.
Safety Warnings common for Grinding, Sanding,
Wire Brushing, polishing, or abrasive cutting-off Operations
1.
this power tool is intended to function
as a grinder, sander, wire brush,
polisher, or cut-off tool. read all safety
warnings, instructions, illustrations
and specifications provided with
this power tool. Failure to follow all
instructions listed below may result in
electric shock, fire and/or serious injury.
2.
Do not use accessories which are not
specifically designed and recommended
by the tool manufacturer. Just because
the accessory can be attached to your
power tool, it does not assure safe operation.
3.
the rateD SpeeD of the grinding
accessories must be at least equal
to the maximum speed marked on
the power tool. Grinding accessories
running faster than their RATED
SPEED can break and fly apart.
4.
the outside diameter and the thickness
of your accessory must be within
the capacity rating of your power
tool. Incorrectly sized accessories
cannot be adequately controlled.
5.
the arbour size of wheels, sanding
drums or any other accessory must
properly fit the spindle or collet of
the power tool. Accessories that do
not match the mounting hardware of the
power tool will run out of balance, vibrate
excessively and may cause loss of control.
6.
Mandrel MOunteD WHeeLS, sanding
drums, cutters or other accessories
must be fully inserted into the collet or
chuck. If the mandrel is insufficiently held
and/or the overhang of the wheel is too
long, the MOUNTED WHEEL may become
loose and be ejected at high velocity.
7.
Do not use a damaged accessory. Before
each use inspect the accessory such as
abrasive wheels for chips and cracks,
sanding drum for cracks, tear or excess
wear, wire brush for loose or cracked
wires. if power tool or accessory is
dropped, inspect for damage or install an
undamaged accessory. after inspecting
and installing an accessory, position
yourself and bystanders away from the
plane of the rotating accessory and run
the power tool at maximum no-load speed
for one minute. Damaged accessories will
normally break apart during this test time.