![background image](http://html2.mh-extra.com/html/harbor-freight-tools/bauer-231210c-b/bauer-231210c-b_owners-manual_4878057017.webp)
Page 17
For technical questions, please call 1-888-866-5797.
Item 58672
Sa
Fety
Opera
ti
O
n
Maintenance
Setup
General Operating instructions
tO preVent SeriOuS inJury WHiLe in OperatiOn:
use personal protective equipment. always wear eye protection.
Wear anSi-approved safety goggles with side shields.
1. Slide Power Switch to OFF position,
then insert a fully charged Battery Pack
making sure it clicks into place.
2. Select an appropriate accessory
for the job. Install accessory.
3. Start the tool by Sliding the Power
Switch to ON position.
4. Use the Speed Dial to increase or decrease
speed. Use a speed appropriate to the
accessory and the material being worked on.
Reference table in
Recommended
Accessory Speeds
on page 12.
5. Apply the accessory to the work material, do
not apply pressure, let the tool do the work.
6. When finished, stop the tool by sliding
Power Switch to OFF position. Wait for
accessory to completely stop spinning before
setting tool down. Remove the accessory
after it has cooled. Store accessories in
the Accessory Storage compartment.
7. To prevent accidents, remove tool’s Battery
Pack after use. Clean, then store the
tool indoors out of children’s reach.
power
Switch
accessory
Storage
Speed
Dial