Page 7
SKU 96695
For technical questions, please call 1-800-444-3353.
The Kennel Hinges (13) are made of two S-shaped halves. Have an assistant
hold the Gate upright while placing one of the Kennel Hinge (13) halves over the
Gate Hinge Post and around the Gate Frame.
please note:
Be sure to posi-
tion the Kennel Hinge half so the slot in the Hinge faces DOWN. See
Figure c
,
below.
Slide the Hinge to the top so that there is a 5” space between the Hinge half and
Kennel Frame.
please note:
As a helpful reference, the top Gate Corner (11)
should be right above the Hinge.
Slide the other half of the Kennel Hinge (13) (with the slot facing UP) into place
so that it locks into the other half. Use a Medium Carriage Bolt (16) to fasten the
Hinge onto the Gate Post. See
Figure c
, above.
Repeat the above steps with the bottom Kennel Hinge. Again, make sure the
Hinge is 5” above the bottom Kennel Frame and resting on the bottom Gate Cor-
ner (11). Use the other Medium Carriage Bolt (16) to fasten the Hinge in place.
To install the Flip Latch (15), place the Latch halfway up the right Gate Support
Post (3), with the slot end facing UP. See
Figure D
, on next page. Make sure
the location does not allow any of the Clips (
7
) to interfere with the Latch’s
operation.
3.
4.
5.
6.
7.
Interlocking
Kennel Hinge
(13) halves
Figure c
Medium
Carriage
Bolt (16)
Clip (7)
Gate Hinge
Post
Gate
Frame
