Page 8
SKU 96695
For technical questions, please call 1-800-444-3353.
Fasten the Latch to the Gate Post by tightening the bolts onto the Latch’s U-bolt.
Make sure that the Flip Latch (15) firmly locks into place and that the Latch slides
up and down easily.
LAciNG WirE sEtup
Attaching the Lacing Wire (14) will fasten the sides of the Fencing to the top and
bottom Kennel Frames, making the Kennel more secure.
please note:
Before attaching the Lacing Wire to the bottom Kennel Frame,
place the Kennel onto a box or cement blocks. This will allow easier access
along the bottom frame and easier Lacing Wire application.
Using pliers (not included) wrap the lacing wire from a Lacing Wire Spools (14)
through the first “diamond-shaped” gap at the top of the Fencing.
please note:
It
may be best to start from the opposite side of the Gate Support Post.
Lace the diamond-shaped gap tight to the top rail. Make sure to pull hard so that
the Fencing is secured tight against the top frame.
Continue lacing the Fencing along the top frame.
please note:
It may be neces-
sary to skip one or two diamond-shaped gaps near the corner Support Posts (3).
(The Lacing Spool (14) may be too large to slide between the Fencing and the
Support Posts.)
After cutting the Lacing Wire (14) (or if the spool run out of wire), tie-twist the end
of the Lacing Wire. Then begin lacing the new Wire Spool through the next dia-
mond-shaped gap.
Continue to lace the top frame until reaching the Gate Latch Post. Cut the Lac-
ing Wire (14) and twist-tie it at the last diamond-shaped gap.
Repeat the same lacing procedure with the bottom frame. Remember to place
the Kennel on a large box or on cement blocks to allow for easier lacing of the
bottom frame.
1.
2.
3.
4.
5.
6.
8.
9.
Flip Latch (15)
Gate Post
Flip Latch
U-bolt
Flip Latch (15)
with slot end
pointed up
Figure D
Clip (7)
