Page 12
For technical questions, please call 1-800-444-3353.
SKU 66908 / 66909
Figure 2
Guide
Bar
Saw
Chain
Chain Tension Screw
(On Model 66909)
Chain Tension
Screw
(On Model
66908)
Nuts
covering
Mounting
Bolts
Drive Cover
If the Saw Chain needs adjustment:
Loosen the Nuts on the Mounting
1.
Bolts on the Drive Cover.
Pull up on the Guide Bar Nose and
2.
hold it up while making the tension
adjustment.
Turn the Chain Tension Screw
3.
clockwise
to apply more Saw Chain
tension, until the Saw Chain makes
contact along the bottom of the Chain
Bar. Turn the Tension Screw 1/4 turn
more.
Continue to hold the Guide Bar Nose
4.
up while tightening the Nut on the
rear Mounting Bolt. Then tighten the
remaining Nut.
After this adjustment is made, check
the Saw Chain tension again by
pulling the Saw Chain away from the
top of the Guide Bar, then making
sure that it can slide along the Guide
Bar. Also, test the tension by pulling
the Saw Chain away from the bottom
of the Guide Bar, then letting it go.
The Saw Chain should snap back
into place in the groove of the Guide
Bar. Repeat the above adjusting
steps if needed to achieve the correct
tension.
adding and/or changing chain Oil
Check the Chain & Bar Oil level
before each use of the Chain Saw
and refill as needed. To add oil,
unthread the Chain & Bar Oil Cap
and fill with Chain & Bar Oil to the
Cap opening. Replace and securely
close the Cap.
Filling the Fuel tank
warning!
tO preVent
seriOus injurY FrOM
Fire:
Mix the fuel (see below) and fill
the fuel tank in a well-ventilated area
away from ignition sources. Do not
smoke.
warning! Your warranty is
voided if: You do not operate
the chain saw with the proper
40:1 fuel mix in its Fuel tank.
never run the engine with an
improper fuel mix, low or no fuel
mix. running the engine with an
improper fuel mix, low or no fuel
mix will permanently damage the
unit. Only use 2-stroke engine oil
for air cooled engines. never use
outboard engine oil.
To obtain the proper 40:1 fuel mix,
1.
combine 2 stroke engine oil with
unleaded gasoline (minimum 90
octane rating) in a clean, approved
container. To mix the fuel:
Add half the amount of fuel and the
a.
entire amount of oil.
Cover and gently shake the fuel
b.
mixture.
Add the remaining amount of fuel.
c.
Cover and gently shake to thoroughly
2.
mix before each fueling. Refer to the
REV 09j
