Harbor Breeze OCEANSIDE, Руководство пользователя

Страница: 11 / 15

6 7
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS
1
4
5
3 6
Lowes.com/harborbreeze Lowes.com/harborbreeze
1. Securely attached the mounting plate (A) to the outlet
box (not included) using two screws (supplied with outlet
box). Pull the black, white and grounded wires out of the
outlet box through the hole in the mounting plate (A) and
lay them to the side.
2. Carefully lift the fan motor (B) and engage the slot in the
motor bracket with the hook on the mounting plate (A)
so that it is securely suspended.
3. Connect the supply GROUNDED/GREEN wire to the
GREEN/GROUNDED wires from the motor bracket
using the wire connector(AA) provided. Connect the fan
motor WHITE wire to the supply WHITE wire using the
wire connector (AA) provided. Connect the fan motor
BLACK and BLUE wires to the supply BLACK wire
using the wire connector (AA) provided.
NOTE: Black wire is hot power for fan. Blue wire is hot
power for light kit. White wire is common for fan and light
kit. Green wire is grounded wire. lf house wires are
different colors than referred to above stop immediately.
We recommend a professional electrician determine
proper wiring.
4. Strip 3/4 in. of insulation from wire ends. Twist stripped
ends together with pliers. Snip ends.
Screw wire connectors on in a clockwise direction. Tape
the connectors and wires together.
WARNING:
The wires should be spread apart with the
grounded conductor and the equipment-grounding
conductor on one side of the outlet box and the
ungrounded conductor on the other side of the outlet box.
Be sure no bare wire or wire strands are visible after
making connection. Place green and white connections
on opposite side of box from the black and blue (if
applicable) connections. The splices should be turned
upward and pushed carefully up into the outlet box.
5. Lift the motor bracket so that the threaded studs on the
mounting plate (A) protrude through the slots in the motor
bracket. Securely tighten the three locknuts (BB) onto
the threaded studs, then try to shake the motor
bracket to ensure that the assembly is tight.
6. Align the four clips on the inside of the motor housing (E)
with the four slots on the outer edge of the mounting
plate (A). Twist the motor housing (E) clockwise until it
stops to hold on the mounting plate (A).
A
A
B
E
B
outlet box
screw
AA
Grounded\Green
Green
White
White
Black
Black Blue
Hardware Used
x 4
Wire connector
AA
2
motor bracket
threaded
stud
motor bracket
BB
A
BB
Locknut
Hardware Used
x 3
A
E
clip
slot