1c.
FINAL INSTALLATION
Connect each blade (J) using the blade bars (L).
On the topside of the blade (J), slide the bent
portion of the blade bar (L) directly under the
opening at the end of the blade bracket (K),
aligning the holes. Then, on the underside of the
blade (J), insert the nodule portion of another blade
bar (L) directly under the same hole. Secure with
one blade screw/washer (AA).
NOTE:
Blade bar (L) must be turned with the
smooth side
toward
the floor.
Repeat step for the remaining blade bars (L) until
the blades (J) are all connected.
CAUTION:
Assistance from another person is
recommended for this step.
Hardware Used
Blade Screw/Washer
x 10
AA
1c
nodule
smooth
side
2.
2
Knobs
Locate two canopy mounting screws (B) on
underside of mounting bracket (A) and remove
canopy mounting screw (B) closest to the open end
of the mounting bracket (A). Partially loosen the
other canopy mounting screw (B). Lift canopy (F) to
mounting bracket (A). Place rounded part of slotted
hole in canopy (F) over loosened canopy mounting
screw (B) and push up. Twist canopy (F) to lock.
Re-insert canopy mounting screw (B) that was
removed, then tighten both canopy mounting
screws (B).
Use arrows on inside of canopy cover (G) to locate
knobs on center ring of canopy cover (G). Slide
canopy cover (G) up to canopy (F), aligning knobs
on canopy cover (G) with openings in bottom of
canopy (F). Press up gently but firmly on canopy
cover (G) until you hear it snap onto the bottom of
the canopy (F) and then turn canopy cover (G)
clockwise about 1/2 in.
14
AA
AA
J
K
L
L
J
L
K
AA
G
B
F
