7
INITIAL INSTALLATION
4.
Secure mounting plate (B) to outlet box
using screws, spring washers, and flat
washers provided with the outlet box. (Fig. 4)
Pull wires from outlet box through center hole
in mounting plate (B).
*
Note: It is very important that you use the
proper hardware when installing the
mounting plate (B) as this will support the
fan.
5.
Remove motor screws (AA) and lock
washers (CC) from underside of motor--
save
to attach blade arms (G) later on
. If there are
also plastic motor blocks, discard them at
this time. (Fig. 5)
Motor
Red Dot
6.
Use the
square
hole in the plate at the top
of the motor assembly (D) and slide it over
the "J" hook on the mounting plate (B) to
support the fan during wiring. (Fig. 6)
Hint
: Place square hole in motor assembly
(D) over “J” hook in mounting plate (B). While
keeping the motor assembly (D) flush with
the mounting plate (B), slide motor assembly
(D) onto “J” hook.
Square Hole
B
D
B
CC
AA
D
3.
Locate motor assembly mounting screws
(FF) on underside of mounting plate (B).
Remove
the motor assembly mounting screw
(FF) with a red dot, along with the lock
washer (GG)--
save for later use
. Partially
loosen
the other two motor assembly
mounting screws (FF). (Fig. 3)
B
Fig. 3
Fig. 4
Fig. 5
Fig. 6
CC
AA
Motor Screw x 10
Hardware Used
5.4 M/M Lock Washer x 10
GG
FF
Motor Assembly x 3
Mounting Screw
Hardware Used
Lock Washer x 3
"J" Hook
GG
GG
FF
FF
