9
Lowes.com/harborbreeze
Slide downrod (A) through opening in mounting
bracket (C) and then turn the downrod (A) so the
straight edges at the top of the downrod (A) align
with the sides of the mounting bracket (C). Pull
down firmly on the downrod (A) until it sits securely
inside the mounting bracket (C).
DANGER:
Failure to secure downrod (A) in
mounting bracket (C) may cause the fan to wobble
or fall, which could result in serious injury or death.
IMPORTANT:
Due to the size (width) of this fan, it
is advisable to seek the help of another person to
hold the stepladder in place and to then help lift the
fan up to you once you are set on the ladder.
6.
FAN MOUNTING
6
A
C
Find a secure attachment point (wood ceiling joist
recommended) and secure safety cable (M). Use a
heavy-duty wood screw, washer and lock washer
(all not included) to secure safety cable (M) loop.
Extra cable slack can be left in ceiling area.
7.
7
Loop
Wood Joist
Wood Screw
and Washer
M
CAUTION:
Be sure outlet box is properly grounded and that a ground (green or bare) wire is
present.
WARNING:
If house wires are different colors than referred to in the following steps, stop
immediately. A professional electrician is recommended to determine wiring.
DANGER:
If using this fan in a DAMP location, this fan must be connected to a supply circuit that
is protected by a Ground Fault Circuit Interrupter (GFCI) to reduce the risk of personal injury,
electrical shock or death.
WARNING:
To reduce the risk of fire, electrical shock, or personal injury, wire connectors
provided with this fan are designed to accept only one 12-gauge house wire and two lead wires from
the fan. If your house wire is larger than 12-gauge or there is more than one house wire to connect to
the corresponding fan lead wires, consult an electrician for the proper size wire connectors to use.
WARNING:
Using a full range dimmer switch (not included) to control fan speed will cause a
loud humming noise from fan. To reduce the risk of fire or electrical shock, do NOT use a full range
dimmer switch to control fan speed.
NOTE:
This fan is not comptible for use with a light kit.
WIRING
