FAN MOUNTING
Depending on the length of downrod you use, you
may need to cut the lead wires back to simplify the
wiring. If you decide to cut back the lead wires, it is
suggested you do so in the following manner:
Take the lead wires and make sure you have pulled
them all the way through the top of the downrod.
Start at the TOP of the downrod and measure 8 in.
of lead wire, and then cut the excess wire off with
wire cutters (not included).
IMPORTANT:
Do NOT
cut safety cable (M).
NOTE:
If you do
not
cut back the lead wires, Steps
4 and 5 are not necessary and you may proceed to
Step 6 instead.
4.
3.
4
A
8
Lowes.com/harborbreeze
Set
Screw
F
A
E
3
D
L
H
Slip downrod (A) into yoke, align holes and
re-install pin (E) and clip (F). Tighten set screws
and nuts in yoke. Slide yoke cover (L) down until it
rests on top of motor assembly (D).
M
If you decided to cut back the lead wires in Step 4,
strip a 1/2 in. of insulation from end of white wire.
Twist stripped ends of each strand of wire within
the insulation with pliers (not included). Repeat
Step 5 for black and green wires.
5.
5
