HANGING INSTRUCTIONS
C
D
1. Hang fan assembly into hanger bracket (C),
making sure groove in hanger ball (D) mates
with tab on hanger bracket (C). Carefully rotate
the fan assembly and hanger bracket (C)
together to orient the fan in the desired
position. (Fig. 1)
2. Once desired position is determined, remove
fan assembly from the hanger bracket (C)
WITHOUT rotating hanger bracket (C). Fully
tighten long lag bolt (HH) in center of hanger
bracket (C) without rotating the hanger bracket
(C). (Fig. 2)
3. Place fan assembly back into hanger bracket
(C) making sure groove in downrod/hanger
ball assembly (D) mates with pin on hanger
bracket (C). Attach the safety cable from fan to
ceiling support cable (JJ). Slide cable clamp
onto safety cable. Place the end of cable
through the loop of ceiling support cable (JJ).
Pull as much cable through loop as possible.
Feed end of cable into clamp hole and firmly
tighten screw. Cut off excess safety cable.
(Fig. 3)
1
Hardware Used
HH
x 1
Long Lag
Bolt
Tab
Rotate
together
HH
C
2
C
KK
JJ
D
3
Tab
Hardware Used
JJ
x 1
Ceiling
Support Cable
KK
x 1
Ceiling Support
Cable Clamp
w/Screw
11
