LEFT HANDEL SWITCHES
DIMMER SWITCH
1
“
'
” position
The headlight low beam and taillight will light up.
“
9
” position
The headlight high beam and taillight will light up. The
high beam indicator on the dashboard will also be lit.
B
CAUTION
Holding the dimmer switch between “
9
” and “
'
”
position will turn on both “
9
” and “
'
” headlight
beams. This operation can damage the motorcycle.
Use the dimmer switch only at “
9
” and “
'
”
position.
Do not stick tape on the headlight or
place objects in front of the headlight.
OVERTAKING SWITCH
2
PASS
Press the switch to flash the headlight.
CLUTCH LEVER
3
The clutch lever is used for disengaging the drive to the
rear wheel when starting the engine or shifting gears.
Grasping the lever disengages the clutch.
HORN BUTTON
4
,
Pressing this button will trigger the horn.
TURNING SIGNAL SWITCH
5
= 8
Moving the switch to the “
=
” position will engage the
left turn signals. Moving the switch to the “
8
” position
will engage the right turn signals. The indicator on the
dashboard will also flash. To cancel turn signal operation,
push the switch inward.
B
WARNING
Failure to use and failure to turn off the turn signals
can be hazardous Other drivers may misjudge your
course and this may result in an accident. Always
use the turn signals when you intend to change
lanes or make a turn. Be sure to turn off the turn
signals after completing the turn or lane change.
CHOKE LEVER
6
(A)
(B)
(C)
To make starting convenient, the motorcycle is provided
with a choke. During a cold engine start, pull the choke
lever to the position (A) and open throttle grip slightly to
start the engine. After the engine is started, pull back
the choke lever by half to position (B) and open throttle
(11)
10
