-10-
wire feeding circuit is short.
7
Power(2A)
Power fuse. The fuse is broken for protecting control transformer while
control electric circuit is short.
8
Voltage indicator
For output voltage adjust while welding
9
Current indicator
For welding current/output current adjust
10
Control
Indicate welding machine if is on or off
11
O.C
Abnormity indicator. If the indicator lights, the inner circuit is abnormal and
machine stops working.
12
Crater Arc
(ON/OFF)
Crater arc selection.
For CO2 welding while it is on
“arc off”
position, press the torch switch
for welding and loosen torch switch for welding stop, and this model is
suitable for short-time welding.
For GMAW welding while it is on
“arc on”
position, press the torch switch
and after arc ignition can loosen the torch switch, the normal welding can be
continued. Press the torch switch again, the arc will be reduced into a less
value which is set by adjusting the knob on front panel, and the weld will be
stop if you loosen the torch switch now. It is suitable for long-time welding.
13
MMA/CO2
Function switch,to chose working condition
14
Gas test/Weld
Gas test/weld selection. On “gas test” position can check the flux of CO2 or
argon; on “weld” position the machine works normally.
15
-
For connection with workpiece.
5.2 Back Panel
R
~
3
电源开
2
1
f
f
X
eff
1
2
I
2
1max
U
0
1
绝缘等级: F
电源关
~
防护等级: IP21S
请勿他用。保险丝8A。
2
2
CO 调节器加热用电源(交流36V),
此为CO 调节器加热专用。仅作为
FIG 5
