Page GB-30
Start-up
Creating a water inlet
NOTICE
Risk of damage!
Improper handling of the appliance
may result in damage.
■
Only use the hose set delivered with
the appliance to connect to the water
supply. Never use old hose sets.
■
Do not connect the appliance to the
hot water supply.
■
Only connect the appliance to a wa-
ter supply with an inlet water pressure
between 0.1 Mpa and 1.0 Mpa (1.0 to
10.0 bar). For higher water pressure,
a pressure regulator needs to be in-
stalled. Enquire about the water pres-
sure with the waterworks.
■
Do not use a pipe wrench to screw
down the union nuts on the valve.
This can damage the union nuts.
For the water supply, you will need a valve
with a 3/4 inch screw connection.
(12)
(28)
(a)
1. Screw down the water inlet hose (a) by
hand onto the connection (12). Then turn
the union nut (28) clockwise.
(26)
2. Secure the end by hand on the valve with
the aqua-stop device on the water inlet
hose. Then turn the union nut (26) clock-
wise.
3. Open the valve completely and check
whether the connections on the appliance
and on the valve are sealed.
4. Then close the valve again.
