page EN-37
Troubleshooting table
Problem
Possible cause
Solution
The indicator (26)
is illuminated although
dishwasher salt has
been added.
The dishwasher salt is
clumpy.
Stir the dishwasher salt using the
end of a spoon or similar.
The water is not
running or it is running
only very slowly.
There is a kink in the inlet
hose.
Arrange the inlet hose properly so
that it is not kinked (please see
“Connect the inlet hose” on page
EN-30).
The water tap is not properly
on.
Turn the water tap on completely.
The filters are blocked.
Clean the filters (38) (see
“Checking and cleaning the filters”
on page EN-26).
The outlet hose (28) is
kinked, has been extended
or is hanging too high up/too
low.
Lay out the outlet hose in a proper
manner (see page EN-29).
The appliance is not
sealed.
The appliance door seal is
defective.
Have the appliance door seal
replaced (see “Service” on page
EN-40).
The outlet hose or the inlet
hose is defective.
Have the defective hose replaced
(see “Service” on page EN-40).
The appliance can be
switched on/off, but
cannot be operated.
The appliance can be
operated only when the door
is closed.
Close the door of the appliance.
The dishwashing results are not satisfactory
Problem
Possible cause
Solution
There are residues or
streaks on the dishes.
The rinse aid is incorrectly
dosed.
Adjust the dispensed dose (see
“Changing the rinse aid dose” on
page EN-14).
The dishwasher salt is
depleted.
Add dishwasher salt (see “Adding
dishwasher salt” on page EN-15).
The dishwasher salt is
clumpy.
Stir the dishwasher salt using the
end of a spoon or similar.