page EN-34
Set-up, connection and initial start-up
Aligning the appliance
To level the appliance, the two front adjust-
able feet (39) and the back foot (39) can be
adjusted by up to 50 mm.
The front adjustable feet are equipped with
slots.
You can adjust the height of the rear adjusta-
ble foot with the centre adjusting screw.
(39)
1. Insert a crosshead screwdriver into one of
the slots of the front adjustable feet and
use it to turn the adjustable feet to the
height required.
2. Insert a crosshead screwdriver into the
middle adjustment screw and use it to
turn the rear adjustable foot to the height
required.
3. Check the alignment with a spirit level.
4. Make sure that the top edge of the ap-
pliance is up to the bottom edge of the
worktop to prevent it from tipping forward
when the appliance door is opened.
Screw the appliance to the
kitchen worktop
(45)
(52)
(48)
or
(52)
If you have granite worktops:
1. Remove the inner, side cover caps (52).
2. Screw the appliance to the kitchen cabi-
nets on the sides using the screws (48).
3. Cover the screws again with the cover
caps.
For all other worktops:
• Screw the mounting brackets (53) firmly
to the worktop with the screws (45).
Water hardness
Determine water hardness
In order to determine the water hardness in
your place of residence, you can
– look on the website of your water provider.
– telephone your water supplier.
– purchase suitable test strips at the phar-
macy.
