Page EN-31
Troubleshooting table
Problem
Possible cause
Solution
The LED (10) is illu-
minated, although dish-
washer salt has been
added.
The dishwasher salt is
clumpy.
Stir the dishwasher salt using the
end of a spoon or similar.
The water is not running
or it is running only very
slowly.
There is a kink in the inlet
hose.
Lay out the inlet hose in such a
manner that it is not kinked.
The water tap is not properly
on.
Turn the water tap on completely.
The water is not running
off or only very slowly.
The filters are blocked.
Clean the filters (see page EN-23).
The outlet hose is kinked, has
been extended or is hanging
too high up/too low.
Lay out the outlet hose in the prop-
er manner (see page EN-25).
The dishwasher is not
watertight.
The door seal is defective.
Have the door seal replaced (see
„Service“ on page EN-33).
The outlet hose or the inlet
hose is defective.
Have the defective hose replaced
(see “Service” on page EN-33).
The dishwasher can be
switched on/off, but can-
not be operated.
The dishwasher can only be
operated when the door is
closed.
Close the door.
The dishwasher cannot
be operated.
The buttons are locked.
Unlock the buttons (see “Button
lock” on page EN-20).
Error indicators
Code
Solution
flashing rapidly
It takes too long for the
water to fill up.
Turn the water tap on completely.
Arrange the inlet hose properly so that it is not kinked (see “Con-
necting the inlet hose” on page EN-26).
Ensure that the water pressure is correct. See “Connecting the in-
let hose” on page EN-26.
flashing rapidly
Water overflow
Switch off the tap. Find the gap in the seal (or have someone find
it) and repair the leak (or have it repaired).
