Hanseatic HG6085E127635S, Руководство пользователя

Страница: 61 / 70

Page EN-26 Setup or under-worktop installation and connection
Connect the outlet hose’s outlet as follows:
Ø ≥ 40 mm
max. 1000 mm
– Option A:
Direct conn ection to the odour seal (si-
phon) of your washing/dishwashing basin.
The outlet hose must be a maximum of
1000 mm above the floor.
– Option B:
Connection to a floor drain.
Connecting the inlet hose
NOTICE
Risk of damage!
The dishwasher is set up for a water
pressure of 0.4 bar to 10 bar (0.04 MPa
to 1.0 MPa). Water must always be able
to run freely into the dishwasher, oth-
erwise this can damage the appliance.
■
For water pressure of less than 10 bar,
install a pressure reducer (in case of
doubt, seek information from the wa-
ter supply company).
■
Never connect the appliance to the
water tap or the mixing arm of a wa-
ter heater (e.g. continuous fl ow heat-
er, pressure-free boiler etc.).
■
Ensure that the inlet hose is correctly
connected and is not kinked or dam-
aged.
■
Do not damage the inlet hose; it con-
tains electrical components. If the in-
let hose is damaged, contact our ser-
vice department (see page EN-33).
3
¾ inch
Inlet hose
For water supply, you need a water tap with
a ¾ inch screw connector.
1. Screw the safety valve’s lock nut to the
tap hand-tight.
2. Check that the connection to the water
tap is sealed. Turn on the water tap slow-
ly and ensure that no water is escaping.
Then close the tap again.
Connecting the dishwasher to
the electricity
WARNING!
Electric shock / fi re hazard!
■
Prior to connecting the dishwasher,
ensure that you have page EN-5 tak-
en note of all the safety instructions
and adhered to them.
Depending on the recess into which the dish-
washer will be fitted, the dishwasher should
be connected before or after fitting.
– For the electrical connection of the dish-
washer, a professional must install an
earthed power socket with its own fuse of
a sufficient size (230 V~/50 Hz/10 A).
– The plug must be installed in such a way
that the recess into which the dishwasher
will be fitted is deep enough even when the
plug is plugged in.