Hansa FCMW971291, Руководство по эксплуатации

Страница: 76 / 124

- 76 -
Removing the catalytic walls
In order to remove the catalytic walls; the guides must be pulled out.
As soon as the guides are pulled out, the catalytic walls will be released
automatically. The catalytic walls must be changed after 2-3 years.
Rack Positions*
It is important to place the wire grill into
the oven properly. Do not allow wire
rack to touch rear wall of the oven. Rack
positions are shown in the next figure. You
may place a deep tray or a standard tray
in the lower and upper wire racks.
Installing and removing wire racks
To remove wire racks, press the clips shown with arrows in the figure,
first remove the lower, and than the upper side from installation location.
To install wire racks; reverse the procedure for removing wire rack.
Changing The Oven Lamp
WARNING: To avoid electric shock, ensure that the appliance circuit is
open before changing the lamp. (having circuit open means power is off)
First disconnect the power of appliance and ensure that appliance is cold.
Remove the glass protection by turning as indicated in the figure on the
left side. If you have difficulty in turning, then using plastic gloves will
help you in turning.
Then remove the lamp by turning, install the new lamp with same
specifications.
Reinstall glass protection, plug the power cable of appliance into electri-
cal socket and complete replacement. Now you can use your oven.
Using The Grill Deflector Sheet*
A safety panel is designed to protect control panel and the buttons when
the oven is in grill mode. (figure 26)
Please use this safety panel in order to avoid the heat to damage control