Hans Grohe LavaPura Uno B305 22400007, Инструкция по использованию/Инструкция по сборке

Страница: 35 / 52

35
Minimum dynamic operating water pressure: 0.08 MPa or more (flowing at 17 L/min or more). The flushing effect
may be affected if failed to meet this pressure.
07
Precautions before installation:
Tips: If no water pressure tester is available, you may refer to the following method.
1. Installation of the mating angle valve
Mark the center line of the outfall on the floor, and install the water inlet angle valve at a proper position on the wall
according to the dimensions of the toilet.
Installation of the ceramic toilet
Open the angle valve to let water flow for 10s. When the water volume reaches 2.85 L or more, the lowest water
pressure of this product can be ensured.
2. Installation of alignment hole cardboard
Align the alignment hole cardboard with the center line of the outfall, draw a corresponding contour line based on the
alignment hole cardboard, and then remove the cardboard.
Measure the floor levelness with a horizon, to make sure the floor of the installation area is level.
Insert the sealing flange into the drain outlet of the toilet;
3. Installation of ceramic toilet
Mount the toilet to the corresponding position according to the drawn contour line.
φ100
Unit: mm
The positions for power supply and water supply on the wall are interchangeable
16A waterproof and splash-proof socket with ground fault circuit breaker
Alignment hole cardboard
300
300
150
Mating water inlet pipe
Mating angle valve
Water storage barrel
305/4
00