7
English
Assembly
Attention!
The fitting must be installed, flushed and
tested after the valid norms.
Operation
The mixer is actuated by lifting the lever head.
Move to the left = hot water,
move to the right = cold water.
The flow is changed from bath to shower function
by pulling the knop at the upper side of the spout.
After shutting off the water flow, the mixer returns
automatically to the bath function.
Technical Data
Operating pressure:
max. 1 MPa
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure:
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
max. 80° C
Recommended hot water temp.: 65° C
Rate of flow 0,3 MPa:
approx. 27/23 l/min
Anti-pollution function:
14466XXX
31466000
31646000
32477000
Hansgrohe single lever mixers can be used toge-
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0,15 MPa.
To adjust the hot water limiter on single lever mixers,
please see page 15.
Don’t install a hot-water-barrier in combination with
flow-heater!
Install the ibox always above the bath-tup. If parts of
the ibox will broken, the water can flow in there!
166XXX/166000/166000/77000:
The safety devices must be checked once a year.
The non return valves must be checked regularly ac-
cording to DIN EN 1717 in accordance with national
or regional regulations (at least once a year).
Spare parts
(see page 3)
1
handle Talis E²
31692000
1.1 screw cover
96338000
2
handle Fcus S
31793000
3
handle Metropol S
14895XXX
4
handle Talis S / Talis S²
32092000
5
handle Metris S
31093000
6
flange
98791XXX
7
flange
98790XXX
8
fixing screw (4)
96454000
9
sub plate
98793000
10 nut
98796000
11 cartridge cpl.
92730000
12 locking screw for handle
96059000
13 seal
95008000
14 diverter knob
98795XXX
15 sleeve
98794XXX
16 selector assy
95014000
17 screw M5 x 20 (4)
96525000
18 noise reduction
94073000
19 vacuum breaker
96753000
20 non return valve
96655000
21 extension 25 mm
13595000
22 extension 22 mm
13597000
XXX
= Colors
000 chrome plated
880 satin chrome
Fault
Cause
Remedy
Mixer stiff
- Cartridge defective, calcified
- Exchange cartridge
Mixer dripping
- Cartridge defective, sedimentation
- Exchange cartridge
Diverter not operating
- Water pressure to low
- Diverter defective
- Increase water pressure
- Exchange diverter
Hot water temperature too low
No cold water
Instantaneous water heater
starts up when cold water is
selected
- Hot water limiter incorrectly set
- Crossflow
- Set hot water limiter
- Exchange cartridge
