10
English
Install the drain
Remove the plunger assembly.
Unscrew the drain outlet flange from the tee.
Unscrew the tailpiece from the tee.
Wrap the threads with Teflon tape and
replace.
Install the flexible sealing gasket on the flange. Sit
it in the sink outlet.
From below, install the black mack gasket, white
friction ring, and retainer nut to the flange. Do not
tighten the nut against the bottom of the sink at
this time.
Thread the tee and tailpiece to the flange. The
pivot must face the faucet. If necessary, turn the
drain assembly.
Tighten the retainer nut.
Sit the plunger assembly in the drain.
Install the horizontal rod through the pivot ball
seals and into the tee so that the end goes through
the loop in the bottom of the height adjuster. The
two pivot ball seals should surround the pivot ball.
Slide the link over end of pull rod. Tighten screw.
Slide one end of spring clip over end of horizontal
rod. Slide link over end of horizontal rod. Test
motion of drain plunger. Reposition link as neces-
sary. There are multiple holes in the link -- the
horizontal rod may go through any of the holes.
When satisfied with the action of the drain, slide
the other end of the spring clip over the end of the
horizontal rod.
