Hanna Instruments HI 92804, Инструкция по эксплуатации

Страница: 7 / 18

13
13
0001 *10.25
#1 20.0 °C
#2 85.5 °C
#3 ---- °C
#4 ---- °C .
.
.
.
a
d b
c
PRINTING / RECORDING PRINTING / RECORDING PRINTING / RECORDING PRINTING / RECORDING PRINTING / RECORDING
WITH HI 92701 AND HI 92704 WITH HI 92701 AND HI 92704 WITH HI 92701 AND HI 92704 WITH HI 92701 AND HI 92704 WITH HI 92701 AND HI 92704
To print the measured values press the PRINT
key. The printout provides the following informa-
tion:
a - Running sample number
b - Time
c - Temperature value
d - Channel number ( HI92704 only)
RECORDING MODE (PROGRAMMED PRINTOUTS)
Press the LOG key to enter the recording mode.
The log number will appear for a few seconds
on the display to indicate the correct opera-
tional mode. The meter will write the first
measurement/s taken in that moment, and
will print at the interval selected thereafter
until the ON/OFF key is pressed.
The printout provides the following information:
a - A running log number
b - A running sample number (in that
particular log)
c - Printing interval indicator in minutes
d - The accumulated time since printing started (HH.MM)
e - Temperature value/s
f - Channel number ( HI 92704 only).
In HI 92704 only, if less then 4 probes are plugged in during
recording mode, the meter will print only the values of the connected
probes.
If probes are added to the remaining channels during the recording
mode, the data from the additional probes will not be printed. Data
from remaining channels can only be added if the recording mode is
exited and a new log number is entered. A
blinking "CH" will appear on the display
next to the channel numbers not utilized
and/or recorded. If more than one channel
is used, the printer will automatically print
all the connected channels.
PRINT
==07== 0005M
0014 *01.05
#1 25.0 °C
#2 27.3 °C
.
.
a
b
f
c
d
e
LOG INTV
LOG
CH
°C
LOG
Untitled-27
14
14
When the meter is in recording mode "LOG"
is displayed on the bottom left corner of the
LCD with the temperature value on the
primary display.
If no keys are pressed, the meter goes to
standby mode to prolong the battery life.
To reactivate the display press the ON/OFF
key.
Notes:
• It is recommended to use the power supply ( HI710005 or
HI710006 ) during recording mode, especially when many
printout are going to be taken.
• Before proceeding with recording, make sure there is enough
paper for your measurements. When the paper is finished the
meter will not advise the operator and the printouts could be
lost.
• It is possible to insert a new paper roll during recording session
(see page 26).
• If the PRINT key is pressed while still
in recording mode, a printout is pro-
duced without affecting the running
number.
• Once in recording mode, the printing interval cannot be
changed. Exit the recording mode first (pressing the
ON/OFF key) before setting the new interval.
TO STOP RECORDING
In order to quit the recording mode, press
the ON/OFF key.
PRINT
ON/OFF
CH
°C
LOG
ON/OFF