Hanlong Technology Co., Ltd Unicorn 600x User Manual Page 37 of 37
Firmware
1.0.0.29 Last Updated 8/2010
9 RESTORE FACTORY DEFAULT SETTINGS
WARNING!
Restoring the Factory Default Setting will DELETE all configuration
information of the phone.
Please BACKUP or PRINT out all the settings before you approach to following steps.
Hanlong will not take any responsibility if you lose all the parameters of setting and cannot
connect to your VoIP service provider.
FACTORY RESET
There are two (2) methods for resetting your unit:
Reset Button
Reset default factory settings following these four (4) steps:
1. Unplug the Ethernet cable.
2. Locate a needle-sized hole on the back panel of the gateway unit next to the power
connection.
3. Insert a pin in this hole, and press for about 8 seconds.
4. Take out the pin. All unit settings are restored to factory settings.
IVR Command
Reset default factory settings using the IVR Prompt (Table 5):
1. Dial “***” for voice prompt.
2. Enter “99” and wait for “reset” voice prompt.
3. Enter 862584658050
NOTE:
1. Factory Reset will be disabled if the
“Lock keypad update”
is set to “Yes”.
2. Please be aware by default the Unicorn 600x WAN side HTTP access is disabled. After
a factory reset, the device’s web configuration page can be accessed only from its LAN
port.
10 TECHNICAL SUPPORT CONTACT
Email:
http://arttel.ru/shop/voip-shlyuzy/golosovoj-shlyuz-hanlong-unicorn-6004
