Hanil J1250, Руководство пользователя, Страница: 54 / 60

USER MANUAL │ J1250
6. Disassembly and maintenance
6.1 Disassembly
6.1.1 Bowl disassembly
·
Check the bowl stop status.
·
Remove the spindle cover. (Attached to the top of the body)
·
Open the Door.
· Separate the coupling nut and bowl under the spindle using coupling and urethane hammer.
·
Remove the Supernatant Outlet & lid.
·
Remove the bowl and place it in the trolley groove.
·
Remove the bowl cap.
(Put the bowl vice on the bottom of the bowl seal and separate it with a bowl wrench)
· For the triangular rotor blade, attach it to the hole at the bottom and safely separate it.
·
Remove the Teflon sheet inside the bowl by pulling it down slowly using your hands.
·
Collect the sludge using Setular.
6.1.2 Drag body assembly disassembly
·
Drag body assembly After removing the nozzle fixing nut, separate the nozzle.
·
Remove the grease pipe. (Use a monkey wrench, turn counterclockwise)
·
Turn the drag handle counterclockwise using a urethane hammer.
·
Hold the lower part of the drag body and turn it counterclockwise, and then separate it from the
lower part of the body.
6.2 Cleaning
· Use a high-pressure nozzle (water) and a bowl cleaner to clean the inside. (Use neutral detergent)
· After placing the bowl cap and body on the trolley, dry them naturally or dry them with a soft, dry cloth
before storage. The areas where the bowl cap and body connection are lead-free blazing are frequently
washed with water and neutral detergent. (Caution: If the bowl is immersed in acid or basic material for
sterilization, the thin film of the blazing coating may peel off or melt, so it is absolutely prohibited)
· If solids remain in the bowl, it may cause vibration. Be sure to clean it every time the operation is stopped.
· Check the condition of the sealing gasket of the bowl cap and remove the material.
· Remove foreign substances from all parts in the drag body assembly.
HANIL Scientific Inc. │ ihanil.com │ Service: +82-2-3452-8966 / techsupport@ihanil.com
54