9
during operation, the pressure is lower than
0.05Mpa
and
should
be
checked
immediately.
Glow indicator [Diesel truck]
Turn the key to ―ON‖ position and the
indicator lights up for a moment. After the
indicator
goes out, turn the key to . ―Start‖
position
Sedimentor indicator [Diesel truck]
In normal state, once the starter is set to
―ON‖ position, this lamp lights up. After the
engine is started up, it goes out.
This lamp lights up when water in sedimentor
reaches to a certain level, while the engine is
running.
Transmission oil temperature warning
light
（
Hydraulic Forklift
）
In normal state, once the starter is set to
―ON‖ position, this lamp lights up. After the
engine is started up, it goes out.
During work time if the oil temperature exceed
the normal rang(60~120
。
C) the indicator light
on.
Caution
If the pointer enters the red range, stop the
operation instantly and slow down engine
speed to cool the coolant and wait until the
pointer goes into the green range, and have
a check then.
Engine fault indicator
[Electronic-controlled engine]
When the engine gets out of order, this
Indicator will be on. then it must immediately
stop, according to an engine fault table
troubleshooting.
Can be judged according to the fault
indicator lamp (flash code), Can be based on
the fault indicator (flash code) judgment, or
ECU diagnostics port connected to diagnostic
equipment, read the fault code information
stored in the ECU.
For more information, see engine manual.
Only Cummins engine forklift truck :
When this light is on, it means one important
engine working is beyond the prescribed
limits of engine protection calibration, engine
power can be reduced, you must stop and
check.
Neutral position start-up indicator
[Electric-switch]
Put the steering handle in the neutral position
when truck on the temporarily stop, the light
will indicated on
The truck can be started up only in the neutral
position.
It‘s prohibited for truck in the neutral position
slip
ing when it‘s on the slope.
OPS indicator
[Optional]
When this light is on, it means driver leave the
seats or not sitting on the seat correctly.
Parking indicator
Parking indicator shows on means brake is
affected, Please loosen the parking handle
(hand brake handle), the parking indicator will
shows off.
Warning
It
will
damage
the
engine
and
transmission, etc. when indicated.
If this lamp continues to stay lit or lights up
during the engine running, stopping the
engine and discharge water immediately.
