Parts Needed
Fuselage assembly
Servo (3) (not included)
Servo lead extension (2) (24") (not included)
Receiver (not included)
Battery pack (not included)
RC foam (not included)
Antenna tube (optional)
Tools and Adhesives Needed
Hobby knife
Drill
Drill Bit: 1/16"
Thin CA
Masking tape
Rubber bands
Step 1.
Install the recommended servo hardware (grommets
and eyelets) supplied with your radio system onto three servos
(elevator, rudder, throttle). Install the servo lead extensions (24")
onto the rudder and elevator servo and secure the connectors by
tying them in a knot or use a commercial connector that prevents
the servo lead and extension from becoming disconnected.
Step 2.
Locate the elevator and rudder servo openings in the
rear of the fuselage. Using a sharp hobby knife, carefully cut
away the covering over the servo openings.
Step 2 photo
Step 3.
Temporarily install the servos into the openings and
mark the location of the servo mounting screws. Remove the
servos and drill the holes for the servo mounting screws using a
1/16" drill bit.
Hint:
Place a drop of thin CA onto each screw hole
to harden the wood around the hole. Allow the CA to
completely dry before installing the servos.
38
Section 14
Installing the Radio System
CONTINUED
