Step 9.
Connect the retract servo to your radio system and
electronically move the servo to the extend position. Slide the
retract control wires through the quick connects as shown and
mount the servo wheel to the retract servo.
Step 10.
With the retract servo in the extended gear position,
pull on the retract wires to manually extend the landing gear.
Tighten the set screws on the quick connects and clip off the
excess wire.
Step 10 photo
Step 11.
Cycle the retract system several times and check to
make sure there is no binding, also check that the landing gear
locks in both the retracted and extended position.
17
Section 5
Installing the Retract Servo
CONTINUED
