STEP 5.
Weight Test EZ-Up Inversion Rack for Proper Installation:
After installing the Locking Brackets and securing the EZ-Up
TM
Inversion Rack in
place:
• Two people should hang by their hands from one end of the rack (one person
on the upper bar and one on the lower bar).
• While hanging, bounce up and down several times. Next, both people should
hang from the other end and repeat the test.
IMPORTANT:
If the door frame is
unstable or weak, DO NOT continue use of the rack in that door frame.
STEP 3.
Final Assembly:
• Slide the smaller half into the larger half.
See Figure 4
. Tighten all bolts
using a screwdriver and wrench. The width of the EZ-Up
TM
Inversion Rack
may be adjusted to fit doorways 28 to 36” (71 to 91 cm) wide by sliding the
smaller half in or out, depending upon the size of your door frame.
STEP 4.
Installation of Locking Brackets:
•
Important:
There are two sizes of Locking Brackets, one to fit the Large
Straight Bar (with blue hand grips) and one to fit the Small Straight Bar (with
red warning label). The Locking Brackets should mount on the door frame
opposite from the hinged door, to allow use of the equipment without interfer-
ing with operation of the door.
See Figure 5.
With your back to the door, the
large Locking Bracket will mount on your left and the small Locking Bracket
on your right.
• Install the first Locking Bracket as shown in
Figure 6
. Place the Locking
Bracket against the doorstop edge, and 2” (5 cm) or more down from the top
of the door frame.
• Mark and then drill three 5/32” (3.9 mm) diameter holes and drill at least 2”
(5cm) deep into the door frame.
• Mount the Locking Bracket using the three wood screws provided (H1-5005).
Screws must fully engage the door frame.
• Install the second Locking Bracket on the opposite side of the door frame at
the same height as the first Locking Bracket. After both Locking Brackets are
installed, extend your EZ-Up
TM
Inversion Rack out to the width of the door
frame and hook the flared tube ends into the u-shaped receiver in each
Locking Bracket.
• Lock the EZ-Up
TM
Inversion Rack into the Locking Brackets by snapping the
plastic, rotating lock over the top of the bar.
See Figure 7
.
IMPORTANT:
Always check to make sure the tubes are securely locked in place before
hanging on the rack.
Figure 4
Figure 6
Figure 7
2
1
3
5
4
6
u-shaped
receiver
plastic
rotating
lock
Figure 5
Assembly Instructions LE-1017 Pg. 2
ASSEMBLY
3. Failure to test installation as outlined in these instructions could lead
to equipment failure, resulting in serious injury or death!
!
WARNING
1. Failure to properly install Locking Brackets could result in equipment failure.
2. Always check to make sure the Inversion Rack is securely locked in place.
WARNING
!
