Handsome Cycles Mud Butler Fender, Руководство по установке

Страница: 12 / 19

25
Pull the fender up and center it into the PVC coated bridge clip. Using
your fingers, fold the tabs of the bridge clip around the fender edges as
tight to the fender as you can. When you are sure the fender is centered
in the clip, crimp down the tabs underneath with needle-nose pliers.
You want the tabs to compress against the inside of the fender as tightly
as possible.
26
You are ready to reinstall your rear wheel. Put the wheel back in the
dropouts, center it and tighten it in place.
22
Remove the bolt from the cork
P
. Install (1) of
M
onto the bolt. Put the
bolt with washer through the slot on the rear fender from the inside.
Install the cork back onto the bolt. Now skip to step 24.
23
Install the bolt
L
with washer
M
into the slot on the rear fender from the
inside.
24
While it is still through the fender, align and install the bolt into the
threaded hole on the chainstay bridge near your bottom bracket using a
4mm hex wrench. If you are using the cork, be sure not to overtighten the
bolt. The cork can deform and split. The rear fender will now be attached
to your frame, but will sag if you let it go. Hold it in place while you go to
step 25.
L (6) SHORTER HEX
HEAD BOLTS
M (6) SMALLER
WASHERS
P LONGER HEX BOLT
WITH CORK